(1) - lap time - External tests conducted by DEKRA TEST CENTRE, on Michelin's request, on Porsche 911 GT3
(2) , in May 2017 on dimensions 235/35-19 and 305/30-19. Gap in terms of average lap time on the circuit of Charade (FR) comparing MICHELIN Pilot Sport Cup 2 to PIRELLI Trofeo R, DUNLOP Sport Maxx Race, YOKOHAMA Advan Neova AD08R and TOYO Proxes R888 R.
(3) - lap time consistency - External tests conducted by DEKRA TEST CENTRE, on Michelin's request, on Porsche Carrera S, in May 2017 on dimensions 235/35-19 and 305/30-19. Regularity evaluated through the evolution of lap time with the number of laps on the circuit of Charade (FR) comparing MICHELIN Pilot Sport Cup 2 to PIRELLI Trofeo R, DUNLOP Sport Maxx Race, YOKOHAMA Advan Neova AD08R and TOYO Proxes R888 R.
RECOMMENDATIONS
- MICHELIN Pilot Sport Cup 2 & MICHELIN Pilot Sport Cup 2 Connect* are semi slick track tyres optimized for dry track use. The ultimate version MICHELIN Pilot Sport Cup 2 R is optimized for extreme dry performance on race tracks.
- On wet tracks or roads semi slick tyres, and especially in a worn state, can be highly impacted by aquaplaning phenomena. Drive carefully and with reduced speeds on wet roads. Make sure as well that the vehicle assistance systems are switched on. However, these tyres meet the legal requirements for use on the public highway and open roads of the countries where it is distributed.
- For track and road handling reasons, the fitting of a set of four tyres is strongly advised.
- Complementary information for the use of MICHELIN Pilot Sport Cup 2 R tyre: as a special tyre for extreme dry conditions, MICHELIN Pilot Sport Cup 2 R requires a warm-up phase, comparable with racing tyres to ensure to reach his optimal performances.
CAUTION
- If not used for a prolonged period of time, remove the tyres (mounted on their wheels) and reduce their pressure to half their normal value to store.
- Store tyres in a clean, dry area, away from direct sunlight and ozone sources (electrical devices and materials/chemicals) and above 0°C (32°F) in accordance with the information provided by Michelin in technical documentation or websites.
- Do not use, store, handle or ship the tyres at ambient temperatures below -10°C (14°F).
- Under these conditions the tyre components can degrade, resulting in reduced performance, and at low temperatures can lead to cracks or damages to the tyre compound and hence reduce potential in use.
- Never use a tyre with cracks, breaks or damage to the sidewall or tread. In case of doubt please consult your local Michelin technical department.
- When used for long periods in an intensive manner on circuits, please be aware that damage can occur to the tyre and its carcass from regularly running over the kerbs at the edges of the circuit.
- It is advisable to visually check the tyres after each run, prior to going back onto the circuit
- In case of prolonged running over the kerbs (or also running heavily off the track) it is advisable to verify the internal condition of the tyre and it’s construction by demounting it from the wheel and having it professionally inspected for any damage, both on the interior and the exterior of the tyre.
GEOMETRICAL SETTINGS (E.G., CAMBER/TOE)
- On the track, geometry settings (camber primarily) can be modified to improve cornering speeds and grip through maximizing tyres' footprint and also to prevent excessive wear/fatigue to the outer shoulder.
- Camber: for optimal results on a track, the negative camber settings should be between -1.5° & -3° dependent upon the track and the type of vehicle. Never exceed -4° of negative camber.
- Camber values for road use must be based upon the recommended « road » settings to ensure the correct handling and behavior for both the vehicle and the tyres.
* Connect function - MICHELIN Pilot Sport Cup 2 Connect tyres are already ready for VDA-compliant Tire Mounted Sensor solutions thanks to the pre-installed Rubber Tire Mount technology. For all intents and purposes, Michelin wishes to warn potential purchasers of MICHELIN Pilot Sport Cup 2 Connect tyres of the need to check the availability of Tire Mounted Sensor solutions on the market; as well as their compatibility with the VDA standard. For your information, the MICHELIN Track Connect kit, which included VDA-compatible Tire Mounted Sensors, has been discontinued since 03/31/2023. If you have any questions, please contact your distributor.